7-12 CHASSIS
TIRES
TIRE REPLACEMENT
• Remove the front and rear wheels. (!7-11)
• After removing the air valve cap, release the tire pressure by
depressing the valve.
• Dismount the bead from the rim completely as shown.
• Separate the tire from the rim by using a set of tire levers and
rim protectors.
$
• Apply tire lubricant to the tire bead and the flange of the rim.
$
$
• Mount the tire on the rim by hand as shown.
NOTE:
Inspect the sealing portion of the rim before installing the tire on
the rim.
When using the tire lever, do not scratch or hit the
sealing portion (hump) of the wheel or it may cause
air-leakage.
Never apply grease, oil, or gasoline to the tire bead
because they will deteriorate the tire.
The standard tire fitted on this vehicle is AT25 ×
8-
12✩✩
✩✩✩✩
✩✩ for the front and AT25 ×
10-12✩✩
✩✩✩✩
✩✩ for the rear.
The use of tires other than the standard may cause
instability. It is highly recommended to use the speci-
fied tire.
To Next Page
Loading...
