ELECTRICAL SYSTEM 8-11
STARTER SYSTEM
TROUBLESHOOTING
Starter
motor
Fuse
Starter relay
B/W
Y/B
R
Neutral relay
Starter
button
Engine
stop switch
Fuse
Ignition
switch
CDI
Parking
brake
switch
Neutral
indicator
light
O/Y
Y/G
Battery
Neutral
switch
N
Bl/B
B/Bl
Starter motor will not run.
The transfer is in neutral. Turn on the ignition
switch with the engine stop switch in the
“RUN” position. Listen for a click from the
starter relay when the starter button is pushed.
Check if the starter motor runs
when its terminal is connected
to the
+
battery terminal (Do
not use a thin wire because a
large amount of current flows.)
Measure the starter relay voltage at the starter
relay connectors (between Y/B
+
and B/W
-
)
when the starter button is pushed.
No click
Clicks
Runs
Voltage
No voltage
• Faulty starter relay
• Loose or disconnected starter
motor lead wire
• Faulty ignition switch
• Faulty engine stop switch
• Faulty neutral relay
• Faulty starter button
• Improper connector contact
• Open circuit in wire harness
Continued on next page
• Faulty starter motor
Does not run
To Next Page
Loading...
