8-26 ELECTRICAL SYSTEM
OPERATING PROCEDURE
INITIAL DISPLAY
When the ignition switch is set to ON, all LCD and engine cool-
ant temperature indicator light light up for two seconds.
NOTE:
If the power supply is cut (e.g., when the battery is replaced);
* The odometer, tripmeter and clock are displayed after the ini-
tial display appears.
* Since the clock resets to “1:00”, it will need to be readjusted.
CHANGE THE DISPLAY MODE
With each press of the ODO/TRIP button, the display changes
between odometer, tripmeter A and tripmeter B as shown.
Hold down the (CLOCK/HOUR) button over two seconds
while pressing the ODO/TRIP button, the display changes
between “mph” and “km/h”, when displaying odometer as
shown.
With each press of the (CLOCK/HOUR) button, the dis-
play changes between clock and hour as shown.
1
ODOMETER
Displays the total distance travelled.
TRIPMETER
Displays the distance travelled since the tripmeter was last
reset.
NOTE:
The tripmeters “A” and “B” can be used independently.
Hold down the ODO/TRIP button over two seconds to reset the
tripmeter.
Odometer Tripmeter A Tripmeter B
mph km/h
Clock Hour
To aboid riding with only one hand, do not operate the
buttons while riding.
To Next Page
Loading...
