3-56 ENGINE
• Install the bearing retainers.
NOTE:
When installing the bearing retainers, apply a small quantity of
THREAD LOCK to the screws.
& 09900-32050: THREAD LOCK “1342”
OIL PRESSURE REGULATOR
• Remove the oil pressure regulator
1.
• When installing the oil pressure regulator
1, tighten it to the
specified torque.
# Oil pressure regulator: 28 N·m (2.8 kgf-m, 20.0 lb-ft)
• Check the operation of the oil pressure regulator by pushing
the piston with an appropriately shaped tool. If the piston does
not operate, replace the oil pressure regulator with a new one.
GENERATOR COVER
DISASSEMBLY
• Remove the generator stator.
To Next Page
Loading...
