ENGINE 3-3
ENGINE REMOVAL AND INSTALLATION
ENGINE REMOVAL
Before taking the engine out of the frame, wash the engine
using a steam cleaner. Engine removal is sequentially explained
in the following steps. Reinstall the engine by reversing the
removal procedure.
• Drain engine oil. (!2-9)
• Drain engine coolant. (!2-12)
• Remove the seat. (!7-4)
• Disconnect the battery lead wires.
• Remove the battery.
"
• Remove the fuel tank covers. (!7-5)
• Remove the mud guard. (L&R) (!7-8)
• Remove the rear carrier and rear fender. (!7-8 and 7-9)
• Remove the fuel tank. (!5-3)
• Remove the right inner fender. (!7-6)
• Disconnect the water hoses.
When disconnecting the lead wires, be sure to discon-
nect the
- battery lead wire first.
To Next Page
Loading...
