CHASSIS 7-71
REASSEMBLY AND REMOUNTING
Reassembly and remounting the rear axle in reverse order of
removal and disassmebly. Pay attention to the following points:
• Apply SUZUKI SUPER GREASE “A” to the hub bearings and
dust seals before installing them.
+ 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Install the hub bearings and dust seal with the special tool.
* 09913-70210: Bearing installer set
NOTE:
When installing the hub bearings to the axle housing, the sealed
cover of inner bearing
1 must face inside, and the sealed cover
of outer bearing
2 must face outside.
• Apply SUZUKI SUPER GREASE “A” to the rear axle shaft
spline.
+ 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
NOTE:
Overall length of RH axle shaft is shorter than LH axle shaft.
• Install the O-ring
3 to the rear drive gear case.
NOTE:
Before installing the O-ring
3, apply grease to it.
To Next Page
Loading...
