7-66 CHASSIS
REAR SHOCK ABSORBER
Inspect the rear shock absorber for oil leakage or damage. If any
damages are found, replace it with a new one.
SWINGARM
Inspect the suspension arm for distortion or damage. If any
damage are found, replace the swingarm with a new one.
REASSEMBLY AND REMOUNTING
Reassembly and remount the rear swingarm and suspension in
the reverse order of removal and disassembly. Pay attention to
the following points:
SWINGARM
• Install the swingarm bearing race and its plate to the swing-
arm by using the special tool.
* 09913-70210: Bearing installer set
NOTE:
When installing the bearing plate, make sure that the bulge of
bearing plate faces inside.
• Apply SUZUKI SUPER GREASE “A” to the swingarm bear-
ings and lips of dust seals, then install them into the swingarm
with the special tool.
+ 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
*09913-70210: Bearing installer set
• Install the spacers to the swingarm.
INSIDE
To Next Page
Loading...
