Suzuki LT-F500F 2002 - Inspection and Disassembly

CHASSIS 7-65
• Remove the pivot spacers
5.
INSPECTION AND DISASSEMBLY
DUST SEAL AND SPACERS
Inspect the spacer and dust seal for wear or damage. If any
damages are found, replace them with new ones.
SWINGARM BEARING
• Remove the dust seals with the special tool.
• Remove the swingarm bearings.
• Inspect the swingarm bearing
1, outer race 2 and bearing
plate
3, if any damages are found, replace the swingarm
bearing with a new one.
* 09913-50121: Oil seal remover
• Remove the swingarm bearing race and bearing plate by
using the special tool.
* 09913-70210: Bearing installer set
$
The removed bearing and dust seal must be replaced
with new ones.