ELECTRICAL SYSTEM 8-15
• Apply SUZUKI SUPER GREASE “A” to the O-ring .
. 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Connect the starter lead wire and the engine ground lead
wire. (!9-14)
STARTER RELAY INSPECTION
• Remove the seat. (!7-4)
• Disconnect the battery
- lead wire at battery terminal.
• Remove the starter relay cover
1.
• Disconnect the starter motor lead wire, battery lead wire and
starter relay coupler at the starter relay.
• Remove the starter relay.
Apply 12 V to the terminals and check for continuity between the
positive and negative terminals using the multi circuit tester. If
the starter relay clicks and continuity is found, the relay is ok.
# 09900-25008: Multi circuit tester set
, Tester knob indication: Continuity test (-)
"
Do not apply a battery voltage to the starter relay for
more than five seconds.
This may overheat and damage the relay coil.
To Next Page
Loading...
