8-12 ELECTRICAL SYSTEM
STARTER MOTOR REMOVAL AND
DISASSEMBLY
• Remove the fuel tank cover. (!7-5)
• Remove the muffler cover. (!7-8)
• Disconnect the starter motor lead wire
1 and engine ground
lead wire
2.
• Remove the starter motor.
Incorrect
• Faulty starter relay
Correct
• Improper starter relay contact
Check the starter relay.
(
:
8-15)
Incorrect
The starter motor runs when the transfer gear position is in neutral, but does not run when the transfer
gear position is in any position other than neutral, with the parking brake lever grasp firmly.
• Open circuit in wire harness
• Poor contact of connector
Engine does not turn though the starter motor runs. • Faulty starter clutch
Check the parking brake switch.
Others
• Faulty parking brake switch
Correct
To Next Page
Loading...
