2-12 PERIODIC MAINTENANCE
• Place an oil pan below the final gear case, and then drain the
oil by removing the drain plug
2 and filler cap
3.
• Tighten the drain plug
2 to the specified torque.
# Final bevel gear oil drain plug:
33 N·m (3.3 kgf-m, 24.0 lb-ft)
• Remove the oil level check bolt
4 and pour the specified oil
through the filler hole until the oil over flows from the oil level
check hole.
• Tighten the filler cap
3 and the oil level check bolt
4.
$ Final bevel gear oil capacity:
250 – 350 ml (8.5 – 10.1 US oz, 8.8 – 10.6 lmp oz)
# Final bevel gear oil filler cap:
33 N·m (3.3 kgf-m, 24.0 lb-ft)
ENGINE COOLANT
ENGINE COOLANT LEVEL CHECK
• Check the engine coolant level by observing the upper
1 and
lower
2 lines on the engine coolant reservoir.
• If the level is below the lower line, add engine coolant until the
level reaches the upper line.
ENGINE COOLANT REPLACEMENT
• Remove the radiator cap lid
1.
Repalce the engine coolant every 2 years.
To Next Page
Loading...
