Suzuki LT-F500F 2002 - Master Cylinder Reassembly and Remounting

CHASSIS 7-61
MASTER CYLINDER REASSEMBLY AND
REMOUNTING
Reassemble and remount the master cylinder in the reverse
order of removal and disassembly. Pay attention to the following
points:
$
' Specification and classification: DOT 4
• Apply the SUZUKI MOLY PASTE to the push rod.
. 99000-25140: SUZUKI MOLY PASTE
• Install the push rod.
• Install the O-ring
1, connector 2 and snap ring 3 to the
master cylinder.
$
• Install the master cylinder.
• Tighten the locknut
4.
# Rear master cylinder rod locknut:
18 N·m (1.8 kgf-m, 13.0 lb-ft)
* Wash the master cylinder components with new
brake fluid before reassembly.
* Do not wipe the brake fluid off with a rag after wash-
ing the components.
* When washing the components, use the specified
brake fluid. Never use different types of fluid or
cleaning solvents such as gasoline, kerosine, etc.
* Apply brake fluid to the master cylinder bore and all
the component to be inserted into the bore.
Replace the O-ring with a new one.