PERIODIC MAINTENANCE 2-21
CHASSIS NUTS AND BOLTS
Check that all chassis nuts and bolts are tightened to their specified torque. (Refer to page 2-22 for the loca-
tions of the following nuts and bolts.)
Tighten initially at 200 km (100 miles, 1 month) and
every 1 000 km (600 miles, 3 months) thereafter.
Item N·m kgf-m lb-ft
1 Handlebar clamp bolt 23 2.3 16.5
2 Steering shaft holder bolt 23 2.3 16.5
3 Steering shaft lower nut 49 4.9 35.5
4 Wishbone arm pivot nut (upper and lower) 65 6.5 47.0
5 Hub nut (front and rear) 110 11.0 79.5
6 Wheel set nut (front and rear) 50 5.0 36.0
7 Steering knuckle pinch bolt (upper and lower) 50 5.0 36.0
8 Front shock absorber mounting nut (lower) 60 6.0 43.5
9 Front shock absorber mounting bolt (upper) 55 5.5 40.0
0 Tie rod end nut 60 6.0 43.5
A Tie rod locknut 29 2.9 21.0
B Brake air bleeder valve (front and rear) 7.5 0.75 5.5
C Brake caliper mounting bolt (front) 26 2.6 19.0
D Brake caliper mounting bolt (rear) 32 3.2 23.0
E Footrest bolt (M8) 26 2.6 19.0
F Footrest bolt (M10) 55 5.5 40.0
G Brake master cylinder mounting bolt (front and rear) 10 1.0 7.0
H Brake hose union bolt (front and rear) 23 2.3 16.5
I Front brake pipe nut 16 1.6 11.5
J Brake pedal bolt 26 2.6 19.0
K Rear shock absorber mounting nut (upper) 35 3.5 25.5
L Rear shock absorber mounting bolt (lower) 60 6.0 43.5
M Rear swingarm pivot bolt (left) 100 10.0 72.5
N Rear swingarm pivot bolt (right) 9.5 0.95 7.0
O Rear swingarm pivot locknut (right) 100 10.0 72.5
P Rear axle housing bolt 55 5.5 40.0
Q Axle housing mounting nut 60 6.0 43.5
To Next Page
Loading...
