3-92 ENGINE
TRANSFER
"
NOTE:
In reassembling the transfer, attention must be given to the locations and positions of washers and circlips.
The cross sectional view given here will serve as a reference for correctly mounting the gears, washers and
snap rings.
* Never reuse a snap ring. After a snap ring has been removed from a shaft, the removed snap
ring should be discarded and a new snap ring must be installed.
* When installing a new snap ring, care must taken not to expand the end gap larger than
required to slip the snap ring over the shaft.
* After installing a snap ring, always ensure that it is completely seated in its groove and
securely fitted.
1
Transfer idle gear
2
Transfer NO. 1 gear
3
Transfer selection
4
Transfer NO. 2 gear
5
Transfer output shaft
6
Transfer driven gear
To Next Page
Loading...
