Suzuki LT-F500F 2002 - Page 133

ENGINE 3-91
• Install the pin
A and water pump drive joint B.
CLUTCH COVER
• Install the dowel pins and new gasket
1.
• Install the water pump drive joint
2.
• Install the clutch cover.
• Install the seal washer to the bolt
A.
• Loosen the locknuts
3 and 4.
• Rotate the adjusting screw
5 counterclockwise until it stops.
• Tighten the locknut
3.
• Rotate the adjusting screw
5 clockwise 1/4 – 2/4 turn.
• Tighten the locknut
4 by holding the adjuster screw 5.
# Locknut
3: 8 N·m (0.8 kgf-m, 5.7 lb-ft)
Locknut
4: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Apply SUZUKI SUPER GREASE “A” to the O-ring and install
the clutch adjuster cap.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)