CHASSIS 7-77
REASSEMBLY AND REMOUNTING
Reassemble and remount the gearshift lever in the reverse
order of removal and disassembly. Pay attention to the following
points:
• Apply SUZUKI SUPER GREASE “A” to the each pivot, sliding
area and lock pins.
+ 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Install the parking switch.
• Install the parking interlock cable with the cable’s claw
A up.
NOTE:
Make sure that the boot
B is fitted securely.
• Install the gearshift covers to the gearshift lever assembly.
• Fit the parking switch read wire’s grommet
1 and parking
interlock cable’s dust cover
2 to the gearshift upper covers
3.
• Fit the gearshift covers to the dust seal
4 on the gearshift
arm pivot.
• Install the lower cover
5.
• Install the gearshift lever assembly to the frame bracket.
• Apply THREAD LOCK SUPER “1303” to the gearshift lever
assembly mounting bolts.
, 99000-32030: THREAD LOCK SUPER “1303”
# Gearshift lever assembly mounting bolt:
29 N·m (2.9 kgf-m, 21.0 lb-ft)
• Connect the each cables to the gearshift lever assembly.
(!7-79 and 7-81)
• Install the front fender. (!7-6)
To Next Page
Loading...
