DRIVE TRAIN 4-35
• Apply THREAD LOCK SUPER “1303” to the rear drive shaft
housing nuts and tighten them to the specified torque.
) 99000-32030: THREAD LOCK SUPER “1303”
( Final drive shaft housing nut:
23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Apply hypoid gear oil to the parking camshaft thrust bearing
1.
• Install the new oil seal to the parking cam cover with the spe-
cial tool, and then apply grease to the seal lip.
# 09913-70210: Bearing installer set
$ 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Install the parking pawl lever and parking camshaft assembly.
• Install the parking pawl lever shaft plug with a new sealing
washer and tighten the plug to the specified torque.
( Parking pawl lever shaft plug:
15 N·m (1.5 kgf-m, 11.0 lb-ft)
• Install the dowel pins and apply sealant to the mating surface
of the cover.
& 99104-31140: SUZUKI BOND “1207B” (USA)
' 99000-31110: SUZUKI BOND “1215” (Others)
To Next Page
Loading...
