4-8 DRIVE TRAIN
UNIVERSAL JOINT YOKE
Inspect the splines of universal joint for wear or damage. If any
defects are found, replace the universal joint yoke with a new
one.
Inspect the universal joint and outer surface of the bearing for
scuffing, wear and damage. If any defects are found, replace the
bearings and universal joint as a set.
Insert the universal joint to the bearing and check the play by
tuming the universal joint, as shown. If excessive play is noted,
replace the bearing with a new one.
FRONT DRIVE GEAR CASE
Inspect the gear case and case cover oil seals for wear or dam-
age.
If any wear or damage is found, replace the oil seal with a new
one.
OIL SEAL REMOVAL !4-5.
To Next Page
Loading...
