6-16 COOLING AND LUBRICATION SYSTEM
• Tighten the impeller securing bolt to the specified torque with
a water pump plier.
% Impeller securing bolt: 15 N·m (1.5 kgf-m, 11.0 lb-ft)
NOTE:
The seal lip side
1 must face to impeller.
• Replace the O-ring with a new one.
NOTE:
Apply engine coolant to the O-ring.
NOTE:
The mechanical seal ring must be assembled with the paint
marked
A face of the ring toward the impeller.
• Install the water pump cover and tighten its mounting bolts
securely.
• Connect the water hoses.
To Next Page
Loading...
