2-10 PERIODIC MAINTENANCE
OIL FILTER REPLACEMENT
• Drian the engine oil. ("2-9)
• Remove the right inner fender. (" 7-6)
• Remove the oil filter
1 using the special tool.
• Apply engine oil lightly to the gasket of the new oil filter,
before installation.
% 09915-40610: Oil filter wrench
• Install the new oil filter to the engine. Turn it by hand until the
oil filter gasket has contacted the oil filter mounting surface.
Then, tighten the oil filter two full turns using the special tool.
% 09915-40610: Oil filter wrench
NOTE:
To properly tighten the oil filter, use the special tool. Never
tighten the oil filter by hand.
• Pour the new engine oil through the oil filler. When performing
the oil filter change, the engine will hold about 3.6 L (3.8 US
qt, 3.2 Imp qt) of oil.
• After three minutes engine idling, check the oil level. ("2-9)
• Add new engine oil and check the oil level. ("2-9)
$ Engine oil capacity
Oil change: 3.4 L (3.6 US qt, 3.0 lmp qt)
Oil and filter change: 3.6 L (3.8 US qt, 3.2 lmp qt)
Engine overhaul: 4.0 L (4.2 US qt, 3.5 lmp qt)
!
After contacting the gasket,
tighten 2 turns.
ONLY USE A GENUINE SUZUKI MOTORCYCLE OIL
FILTER.
Other manufacture’s oil filters may differ in thread
specifications (thread diameter and pitch), filtering
performance and durability which may lead to engine
damage or oil leaks. Also, do not use a GENUINE
SUZUKI AUTOMOBILE OIL FILTER on this vehicle.
To Next Page
Loading...
