7-16 CHASSIS
• Remove the inner race with a bearing puller.
• Remove the boot.
$
NOTE:
* Wash the disassembled parts (except for the boot). After
washing, completely dry the parts using compressed air.
* Clean the boots with a cloth.
$
• Fit a boot on the drive shaft end, fitting the small diameter side
of the boot to the shaft groove, fix its end with a new band.
• Install the cage
1 on the shaft.
$
A Large diameter
B Small diameter
• Drive in the cage
1 by using a pipe
2.
Drive shaft joint cage installing pipe diameter
A : 20.0 mm (0.787 in) or more
B : 27.0 mm (1.063 in) or less
$
Do not disassemble the wheel side joint (double offset
joint). If any damages are found, replace the wheel
side joint with a new one.
* Wash all parts before installation, clean the inside
and outside of the boot with a cloth.
* Do not wash the boots in any commercially available
degreaser, such as gasoline or kerosene. Washing in
a degreaser causes deterioration of the boot.
Install the cage with the large diameter side facing the
shaft end.
Install cage directing smaller outside diameter side to
wheel side.
To Next Page
Loading...
