7-56 CHASSIS
• Assemble the caliper holder and the caliper.
NOTE:
Make sure that the boots must be set into the holder pin’s
grooves securely.
• Install the piston, insulator and spring.
• Install the pads to the caliper. (!7-51)
• Tighten the brake caliper mounting bolts
3, and brake hose
union bolt
4 to the specified torque.
(Rear brake hose routing: !9-21)
# Brake caliper mounting bolt:
32 N·m (3.2 kgf-m, 23.0 lb-ft)
Brake hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
NOTE:
Before remounting the brake caliper, push the brake caliper pis-
ton all the way into the caliper.
$
&
* The seal washers should be replaced by the new
ones to prevent fluid leakage.
* Bleed air from the brake system after reassembling
the master cylinder. (!2-16)
Brake fluid, if it leaks, will interfere with safe running
and discolor painted surfaces. Check the brake hose
and hose joints for cracks and oil leakage.
To Next Page
Loading...
