8-18 ELECTRICAL SYSTEM
Measure the ignition coil primary peak
voltage. (
:
8-19)
NOTE: The ignition coil peak voltage
inspection method is applicable only with the
multi circuit tester and the peak volt adaptor.
Inspect the ignition coil. (
:
8-20)
Measure the pickup coil and power source
coil resistance. (
:
8-20)
Inspect the spark plug.
(
:
2-7)
• Faulty spark plug
• Improper spark plug
connection
• Faulty pickup coil
• Faulty power source coil
• Faulty ignition coil
• Faulty CDI unit
• Open circuit in wiring
harness
• Improper ignition coupler
connection
Correct
Correct
Incorrect
Incorrect
Incorrect
Correct
Incorrect
Correct
To Next Page
Loading...
