Suzuki LT-F500F 2002 - IGNITION COIL RESISTANCE; PICKUP COIL AND POWER SOURCE COIL RESISTANCE

8-20 ELECTRICAL SYSTEM
IGNITION COIL RESISTANCE
• Remove the fuel tank cover. (!7-5)
• Disconnect the ignition coil lead wire and spark plug cap, and
remove the ignition oil.
Measure the ignition coil resistance in both the primary and sec-
ondary windings using the multi circuit tester. If the resistance in
both the primary and secondary windings is close to the speci-
fied values, the windings are in sound condition.
# 09900-25008: Multi circuit tester set
) Tester knob indication: Resistance (Ω
ΩΩ
Ω)
& Ignition coil resistance
Primary : 0.1 – 1.5 Ω
ΩΩ
Ω (Terminal – Ground)
Secondary : 12 – 22 kΩ
ΩΩ
Ω (Spark plug cap – Terminal)
PICKUP COIL AND POWER SOURCE COIL RESISTANCE
• Remove the fuel tank cover. (!7-5)
• Disconnect the generator coupler
1.
Measure the resistance between the lead wires using the multi
circuit tester. If the resistance is not within the spcified value,
stator coil must be replaced.
# 09900-25008: Multi circuit tester set
) Tester knob indication: Resistance (Ω
ΩΩ
Ω)
& Pickup coil resistance: 150 – 300 Ω
ΩΩ
Ω (Blue – Green)
Power source coil resistance:
0.05 – 1.0 Ω
ΩΩ
Ω (Yellow – White)