8-24 ELECTRICAL SYSTEM
First check the insulation between
B and
C and between
A
and
C terminals with the tester.
Apply 12 V to the terminals as shown in Fig-1, and check the
continuity between
B and
C.
Apply 12 V to the terminals as shown in Fig-2, and check the
continuity between
A and
C.
If there is no continuity, replace the 2WD/4WD selecting relay
with a new one.
2WD SWITCH AND 4WD SWITCH
• Remove the 2WD/4WD motor. (!8-23)
• Disconnect the switch couplers (
1,
2).
• Remove the 2WD switch
3 and 4WD switch
4.
Measure 2WD switch and 4WD switch for continuity using a
multi circuit tester. If there is no continuity, replace the 2WD
switch and 4WD switch with a new one.
# 09900-25008: Multi circuit tester set
• Install the 2WD switch and 4WD switch. (!4-15)
Fig-1
Fig-2
Color
Position
R/W
R/W
To Next Page
Loading...
