8-36 ELECTRICAL SYSTEM
NOTE:
If no air bubbles are coming up from a filler port, tap the bottom
of the electrolyte container two or three times.
Never remove the container from the battery.
• After confirming that the electrolyte has entered the battery
completely, remove the electrolyte containers from the bat-
tery. Wait for about more than 20 minutes.
• Insert the caps into the filler holes, pressing in firmly so that
the top of the caps do not protrude above the upper surface of
the battery’s top cover.
"
• For initial charging, use the charger specially designed for MF battery.
"
* Never use anything except the specified battery.
* Once install the caps to the battery; do not remove
the caps.
* Do not tap the caps with a hammer when installing
them.
INCORRECT
CORRECT
* For charging the battery, make sure to use the charger specially designed for MF battery. Oth-
erwise, the battery may be overcharged resulting in shortned service life.
* Do not remove the cap during charging.
* Position the battery with the cap facing upward during charging.
To Next Page
Loading...
