Suzuki LT-F500F 2002 - DRIVE TRAIN;GEARSHIFT CAM

ENGINE 3-23
• Remove the right crankcase bolts.
• Separate the crankcase with the special tool.
NOTE:
* The crankcase separator plate is parallel with the end face of
the crankcase.
* The crankshaft must remain in the left crankcase half.
( 09920-13120: Crankcase separator
DRIVE TRAIN/GEARSHIFT CAM
• Remove the gearshift fork shafts
1.
• Remove the reverse gearshift fork, No. 1 and No. 2 gearshift
forks, and then pull out the gearshift cam
2.
• Remove the reverse shift cam
3.
• Remove the reverse dog
4 washer 5, the reverse idle gear
6 and shaft 7.
• Remove the driveshaft and countershaft assembly.