Power saver function
The saving of the internal source of the instrument’s power can be achieved
by reducing the brightness of the screen when possible.
There are two options for the power saver function. The screen may be
switched off (Screen off on idle) and/or dimmed (Dim screen on idle).
When either of these options are set, after a delay from pressing any push-
button, defined by the parameters Dim screen delay or Screen off delay, the
screen is dimmed or switched off. If it has happened, the first press of any
push-button will cause the screen to switch back on again.
Power saver delay
The power saver delay defines the delay period from last use of any push-
button to the power saver mode. This delay period can be set for
Dim screen on idle from 5 s to 60 s and for Screen off on idle from 1 m to
60 m. The <ENTER> push-button must be pressed for confirmation of the
selection, which then also closes the Screen Setup window.
To Next Page
Loading...
