F73 – Alarm Control / Status
To display the latched faults, enter:
F73 LATCH
The XL-GPS responds in the following format:
F73<SP>LATCH<SEP><123456789ABCDE><CR><LF>
The values in <123456789ABCDE> field indicate the latched faults, if any, which have
occurred since the last time Alarm Latch was cleared.
To clear the Alarm Latch, enter:
F73 CLEAR ALARM LATCH<CR><LF>
The XL-GPS clears Alarm Latches and responds:
OK<CR><LF>
The user can enable or disable the alarm indicators using the MASK command. To display
the current mask, enter:
F73 MASK
The XL-GPS responds in the following format:
F73<SP>MASK<SEP><123456789ABCDEFGHIJ><CR><LF>
Where the value of each character in <123456789ABCDEFGHIJ> field is either 'E' or 'D'. 'E'
means the corresponding indicator is enabled, and can trigger an alarm if it enters a fault
state. 'D' means the indicator is disabled (or not available) and will not trigger an alarm if it
enters a fault state.
To enable ('E'), disable (‘D’), or leave the indicator unchanged (‘-’), enter 'E', 'D', or '-' for
each character in <123456789ABCDEFGHIJ> when you enter the following string:
F73<SP>MASK<SEP><123456789ABCDEFGHIJ><CR>
The XL-GPS will sets the new alarm mask and responds:
OK<CR><LF>
The following summarizes the fault alarm mask setting in the <123456789ABCDEFGHIJ>
field:
1 =
'E' PLL Synthesizer Alarm Enabled
098-00116-000 Rev. A............................... Page 101 of 221
To Next Page
Loading...
Need help?
General
