5: Function Reference
In Dynamic Mode: The system has been instructed by the user that its position could change
and has set the GPS mode to Dynamic Mode (see “F53 – GPS Operation Mode” on page
79):
• Stop Site Survey: The receiver has finished checking for changes in its static
position.
• Stop TRAIM: The receiver has completed TRAIM monitoring.
• Dynamic Mode: The position is being resolved on an ongoing basis.
Command Line
To obtain the status of the GPS Receiver, enter:
F119<S>S<CR>
For example, enter:
F119 S<CR>
XL-GPS responds (example):
F119 :<CR><LF>
SOFTWARE 084-00215-000vP2_V&V_8<CR><LF>
FPGA 084-00216-000v1<CR><LF>
GPS STATUS LOCKED<CR><LF> (or UNLOCKED)
GPS ANTENNA OK<CR><LF> (or SHORT or OK)
GPS ACQUISITION STATE: DYNAMICMODE (or one of the following:
DYNAMIC MODE,
STOP SITE SURVEY,
STOP TRAIM,
START SITE SURVEY,
SURVEY POSITION,
POSITION HOLD,
TRAIM ACTIVE)
where:
F
= ASCII character F.
119
= function number.
<S>
= ASCII space character one or more.
<CR><LF>
=
line terminator, either a carriage return and line feed for output strings or a carriage
return only for input strings.
Page 146 of 221 .................................098-00116-000 Rev. A
To Next Page
Loading...
Need help?
General
