SYNAPTICON SOMANET Node 400 User Manual

are connected to
The network adapter has to be an Ethernet connection, so it likely starts with “eth”
Save changes
7. Power up and
connect the slaves
To connect your host PC with the servo drive, simply plug the EtherCAT cable on your Ethernet port (rj45) of
your PC and connect it to the servo drive on EtherCAT port IN.
Details about this connector for
SOMANET Node
and
SOMANET Circulo
.
8. Play the virtual machine
9. In case your systems hints that a swap partition is needed:
Synapticon Documentation
© 2021 Synapticon GmbH | Daimlerstraße 26 | D-71101 Schönaich Documentation v 4.11.0 | Built 2021-07-23 323/887

SYNAPTICON SOMANET Node 400 Specifications

General

Brand	SYNAPTICON
Model	SOMANET Node 400
Category	Servo Drives
Language	English