Receipt of Equipment
When the equipment is received the outside packing case should be checked immediately for any shipping damage.
If the packing case has been damaged, the local carrier should be notified at once regarding his liability. Carefully
remove the unit from its packing case and inspect for damaged or missing parts.
If damage has occurred during shipment or parts are missing, a written report should be submitted to the Customer Ser-
vice Department, FMC Technologies Measurement Solutions, Inc., 1602 Wagner Avenue, Erie, Pennsylvania 16510.
Prior to installation, the unit should be stored in its original packing case and protected from adverse weather
conditions and abuse.
Caution:
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with this Instruction Manual, may cause interference to radio communications. It has not
been tested to comply with the limits for a Class A computing device pursuant to Subpart J of Part 15 of
FCC Rules, which are designed to provide reasonable protection against such interference when operat-
ed in a commercial environment. Operation of this equipment in a residential area is likely to cause inter-
ference, in which case the user, at his own expense, will be required to take whatever measures may be
required to correct the interference.
Warning
These preset devices must be used with fail-safe backup equipment to prevent accidental runaway delivery of
product. Failure to provide backup equipment could result in personal injury, property loss and equipment damage.
Warning
On initial power-up of a new unit or after installation of a new computer board, there are several alarms that will
be triggered which cannot be cleared until the AccuLoad is programmed.
United States NIST Handbook 44 UR.3.5.1. and UR.3.5.2.
For compliance to United States NIST Handbook 44 UR.3.5.1. and UR.3.5.2., invoices printed using a mechanical
numeric-only printer (e.g., Smith Meter Load Printer) must contain in preprinted form the following information:
a. Volume corrected to 60 degrees F
b. API/C of E _____________________
c. Temperature ____________________
d. Gross Volume ____________________
where the API/C of E, temperature, and gross volume may be hand-written on the ticket. Refer to Handbook 44,
UR.3.5.1. and UR.3.5.2. for current requirements.
To Next Page
Loading...
Need help?
General
