Section I – Introduction
MN06135 Issue/Rev. 1.3 (6/17) 2
Operation of this equipment in a residential area
may cause interference, in which case the user, at
his own expense, will be required to take whatever
measures that may be required to correct the inter-
ference. The AccuLoad has been evaluated against
the standard EN 61326-1: “Electrical equipment for
measurement, control and laboratory use” and has
been found to comply to the European Community
EMC Directive 2014/30/EU.
Weights and Measures Requirements
The AccuLoad is a device marketed for a global
market. Requirements vary depending on the region.
It is a user requirement to verify that the AccuLoad is
programmed and operated in a manner consistent
with local codes and that proper notification (permit
for use) or registration has been filed with the local
authority or jurisdiction.
To Next Page
Loading...
