Tektronix TDS5000B Series Service Manual

Commands
5-20
TDS5000B Series Service Manual
Table 5- 5: DIAgnostic Commands
Command Description
DIAg:STOP Terminates the execution of diagnostics
TEST Selects and executes any item at any level of the
test hierarchy
TEST:RESults? Returns a brief pass or fail status of the last test
execution
TEST:RESults:VERBose? Returns a more explanatory message about the
results of the last test execution
TEST:STOP Terminates the execution of the test
DIAg:CONTROL:HALT
This command (no query form) determines whether the next execution of
diagnostics will stop on the first diagnostic failure that occurs or will execute the
selected set of diagnostic functions. This command is equivalent to selecting
Instrument Diagnostics from the Utilities menu and then enabling Halt on Fail.
DIAg:CONTROL:LOOP
DIAg:CONTROL:HALT (ON|OFF|<NR1>)
ON enables the halt function, causing the execution of diagnostics to halt at the
first diagnostic failure that occurs.
OFF disables the halt function, allowing the instrument to execute the entire set
of diagnostics before halting, even if a diagnostic failure occurs.
<NR1> A 0 enables the halt function; any other number disables the halt
function.
DIAg:CONTROL:HALT ON
This command enables the halt function, causing the execution of diagnostics to
halt at the first diagnostic failure that occurs.
Related C ommands
Syntax
Arguments
Example

Tektronix TDS5000B Series Specifications

General

Brand	Tektronix
Model	TDS5000B Series
Category	Test Equipment
Language	English