Commands
5-34
TDS5000B Series Service Manual
TEST
This command (no query form) provides the ability to select and execute an item
at any level of the test hierarchy (Test, Area or Subsystem). This command is
equivalent to selecting Instrument Diagnostics from the Utilities menu, choosing
a test and then pressing R un.
NOTE. Turning off both DIAg:CONTROL:HALT and DIAg:CONTROL:LOOP
before executing the TEST command is r ecommended.
TEST <NR3>
<NR3> sets the test ID, which ranges from 0 through 3 characters. If no test ID
is specified, all available diagnostics are executed.
TEST ”1”
executes all Acquisition tests (Subsystem: Acquisition)
TEST ”11”
executes all Acquisition Memory tests (Subsystem: Acquisition, Area:Memory)
TEST ”113”
executes a specific Acquisition Memory test (Subsystem: Acquisition, Area:
Memory, Test: Address Lines).
TEST:RESults?
This query-only command returns an abbreviated status about the results of the
last TEST execution. This command is equivalent to selecting Instrument
Diagnostics from the Utilities menu and then reviewing the Diagnostic Status.
TEST, TEST:RES ults:VERBose?
TEST:RESults?
TEST:R ESults?
Syntax
Arguments
Example 1
Example 2
Example 3
Related C ommands
Syntax
Example 1
To Next Page
Loading...
Need help?
General
