EasyManua.ls Logo

Tektronix TDS5000B Series

Tektronix TDS5000B Series
237 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Removal and Inst a l l a t i on Procedures
TDS5000B Series Se r vi c e Manual
6-- 11
c. Slide the right side panel towards the rear of t he oscilloscope a l l owi ng
the tabs to clear the cover openings, then pull out to remove the panel
from the osci l l osc ope .
4. Remove the V GA panel: Use Figure 6--2, page 6--13 as a guide.
a. Remove the VGA panel by gently pulling the trim up and out from the
oscilloscope.
5. Remove the pouch: Use Figure 6--2, page 6--13 as a guide
a. Unsnap the pouch from the top cover.
b. Re m ove the two T-15 TORX drive screws that secure the power cord
retainers and pouch bracket at the top rear of the oscilloscope.
6. Remove the t op cover: Use Figure 6--2, page 6--13 as a guide.
a. Remove the ac c e ssor y tray door or printer door.
b. I f installed, re m ove the accessor y tray or internal printer (two T-15
TORX drive screws) .
c. If the internal printer is installed, disconnect the cable from the printer.
d. Sl i de the top cover towards the rear of the oscill osc ope allowing the tabs
to clear t he cover openings, then pull out to re m ove the cover from the
oscilloscope.
7. Remove the f ront panel trim:
a. To prevent the power button f r om falling out of the front panel trim,
place a pie c e of tape over the button.
b. Re m ove the three T-15 TORX drive screws t ha t secure the front panel
trim to the oscilloscope.
c. Grasp the trim ring by its top edge and pull toward you to detach the
three plastic snaps. (Alternatively, you can use a flat-bladed solder aid or
other small prying tool to help you detach the snaps.)
d. Gr a sp the trim ring by its side edges and slide it back and forth to release
the snap in the middle of the t r im ring. The snap is at the bottom “T” of
the front pane l above the channel 1 and 2 BNCs.
e. Pull off t he trim ring. As you do so, take care not to lose the 3 pem
inserts in the bottom of the trim ring.

Table of Contents

Other manuals for Tektronix TDS5000B Series

Related product manuals