Removal and Inst a l l a t i on Procedures
TDS5000B Series Se r vi c e Manual
6-- 35
1. Locate module to be removed: Loca t e the CDRW assembly in the locator
diagram Internal Modules, Figure 6--7, on pa ge 6--19. Note the location of
cables and c a bl e connectors see Figure 6--17 on page 6--32. Additional
modules to be removed:
! Trim (all exce pt front panel and acquisition)
! Right side cover
! Printer frame (SN B029999 and below)
! Floppy disk drive
2. Orient the osci l l osc ope : Set the oscilloscope so the bottom i s down on the
work surface a nd the right side panel is facing you.
3. Remove the CDRW Disk Driv e assembly: See Figure 6--20, on page 6--37.
a. Verify that the oscilloscope is powered off.
b. Re m ove the T-15 TORX drive screw that secures the CDRW Disk Drive
assembly to the chassis.
c. Pull the CDRW Disk Drive assembly away from the chassis far e nough
to disconnect t he cables See Figure 6--20.
4. Remove the CDRW Drive f rom the assembly: See Figure 6--19 .
a. Remove the four Phillips scre ws that secure the drive to the bracket.
b. Ge nt l y pull the drive away from the c onne c t or and remove the drive
from the bracket.
CDRW Disk Drive
To Next Page
Loading...
