Tektronix TDS5000B Series Read This First

TDS5000B Series Service Manual
9-1
Diagrams
This section describes the electrical operation of the TDS5000B Digital
Oscilloscope using the major circuit blocks. Figure 9--1 on page 9--2 shows the
oscilloscope module interconnections.
Symbols
Graphic symbols and class designation letters are based on ANSI Standard
Y32.2--1975. Abbreviations are based on ANSI Y1.1--1972.
Logic symbology is based on ANSI/IEEE Std 91-1984 in terms of positive logic.
Logic symbols depict the logic function performed and can differ from the
manufacturer’s data.
The tilde (~) preceding a signal name indicates that the signal performs its
intended function when in the low state.
Other standards used in the preparation of diagrams by Tektronix, Inc. are:
! Tektronix Standard 062--2476 Symbols and Practices for Schematic Drafting
! ANSI Y14.159--1971 Interconnection Diagrams
! ANSI Y32.16--1975 Reference Designations for Electronic Equipment
! MIL--HDBK--63038--1A Military Standard Technical Manual Writing
Handbook

Tektronix TDS5000B Series Specifications

General

Brand	Tektronix
Model	TDS5000B Series
Category	Test Equipment
Language	English