Tektronix TDS5000B Series Read This First

Commands
5-8
TDS5000B Series Service Manual
Table 5- 4: C A Libr a te commands (Cont.)
Command Des c ripti on
CALibrate:INTERNal:STATus? Returns the current status of the internal signal path
calibration
CALibrate:PROBEstate:CH<x> Returns the c a libration status of the attached probe
CALibrate:RESults? Returns the s tatus of all calibration subsystems
wit h out performing an SPC operation
CALibrate:RESults SPC? Returns the results of the last SPC operation
*CAL?
This query-only command instructs the digitizing oscilloscope to perform a
signal path compensation and return its calibration status. This command is
equivalent to selecting Instrument Calibration from the Utilities menu and then
clicking the Calibrate button.
NOTE. The self-calibration can take several minutes t o respond. No other
commands will be executed until calibration is complete.
CALibrate:RESults:SPC?
*CAL?
0 <NR1> indicating that the calibration did not complete successfully
1 (or any non-zero value) <NR1> indicating that t he calibration completed
without errors
*CAL?
might return
1
indicating that the calibration was successful.
Related Commands
Syntax
Returns
Example

Tektronix TDS5000B Series Specifications

General

Brand	Tektronix
Model	TDS5000B Series
Category	Test Equipment
Language	English