Textron MPE 850 OFF-ROAD - Page 35

35TD410023-B RLF
11
8
13
14
12
10
9
ENGINE DISASSEMBLY
The cylinder head gasket must be replaced after
removal. When press-in the cylinder liner, you can
use the used cylinder head gasket.
12. Apply the cylinder head gasket.
Observe the installation position:
– Exhaust side
8
– Centering pins
9
– Inscription
12
13. Place the cylinder head on the crankcase.
Observe the installation position:
– Exhaust side
10
– Chain tensioner
11
14. Insert four cross bars
14
. (See the following
assembly instruction for cross bars.)
15. Install eight nuts
13
according to the
specification First stage cylinder head nuts.
(See section D Tightening torques und
assembly instructions.)
16. Wait 15 minutes.
17. Remove the cylinder head nuts in reverse
order and remove the cylinder head.
18. Remove the crankcase bolts in reverse order
and remove the lower case.
ASSEMBLY INSTRUCTION FOR CROSS BARS
– Counterbore
1
– Sleeve
2
A
1
2