Toro Multi Pro 1750 - Page 56

Figure118
AgitationValveManifold
1.Stemretainer7.BackseatingO-ring(0.676
inch/0.07inch)
2.Valvestem8.Valve-seatring
3.Stemport9.Manifoldbody
4.Stemretainer
10.Ballvalve
5.End-captting11.Quickconnect
6.End-cap-sealO-ring
(0.796inch/0.139inch)
Figure119
SectionValveManifold
1.Valve-stemseat
7.EndcapO-ring(0.796inch
/0.139inch)
2.Valve-stemassembly
8.BackseatingO-ring(0.676
inch/0.07inch)
3.Stemport
9.Ballseat
4.Stemretainer10.Manifoldbody
5.OutletttingO-ring(0.737
inch/0.103inch)
11.Ballvalve
6.End-captting12.End-cap-ttingassembly
3.TurnthevalvestemsothattheballisintheOPEN
position(Figure117).
Note:Thevalvestemshouldbeparallelwiththevalve
owandtheballshouldslideout.
4.Removethestemretainerfromtheslotsinthestem
portinthemanifold(Figure118andFigure119).
5.Removethestemretainerandvalve-stemseatfromthe
manifold(Figure118andFigure119).
6.Reachintothemanifoldbodyandremovethe
valve-stemassembly(Figure118andFigure119).
7.Cleantheinsideofthemanifoldandexteriorofthe
ballvalve,valve-stemassembly,stemcapture,andend
ttings.
56