Toro Multi Pro 1750 - Page 248

Multi Pro 1750Page 7 − 22Drive Train
5. Remove center plate assembly:
A. Loosen and remove fifteen (15) flange head
screws and separate center plate from transaxle
case. Note dowel pins in transaxle case.
B. Remove seal cap, shims and snap ring from cen-
ter plate.
C. Remove input shaft cover and seal from center
plate. Discard seal.
1
4
2
3
1. Seal cap
2. Shims
3. Shim
4. Snap ring
5. Input shaft cover
6. Input shaft seal
Figure 18
5
6
6. Remove reverse shaft from transaxle case.
1
2
1. Reverse shaft 2. Bearing (gear case)
Figure 19
7. Remove main shaft assembly together with fork
shaft assembly from transaxle case.
1
2
1. Main shaft assembly 2. Fork shaft assembly
Figure 20