Multi Pro 1750 Page 7 − 23 Drive Train
8. Remove, all at the same time, reduction shaft as-
sembly, 2nd−3rd shift assembly and countershaft as-
sembly.
1
2
3
1. Reduction shaft
assembly
2. 2
nd
−3rd shaft assembly
3. Countershaft assembly
Figure 21
9. Loosen flange head screws and remove L.H. axle
shaft assembly and shims from L.H. side cover still at-
tached to transaxle.
1. Flange head screw (5)
2. L.H. axle shaft assembly
3. Shims
4. L.H. Side cover
Figure 22
10.Remove roll pin from differential lock lever and re-
move lever from shaft. Loosen and remove five (5)
flange head screws. Remove L.H. side cover from trans-
axle case.
11.Inspect side cover for cracks or damage and replace
if necessary.
12.Remove differential lock shaft seal from cover and
discard seal.
1
2
3
1. Lever
2. Flange head screw (5)
3. L.H. Side cover
Figure 23
Drive Train
To Next Page
Loading...
