Multi Pro 1750Page 7 − 26Drive Train
18.Remove oil cap and O−ring from transaxle case if
necessary.
19.Remove air breather if necessary.
1
2
1. Oil cap 2. Air breather
Figure 30
20.If necessary, remove flange head screw and slide
speed sensor from upper cover.
21.Loosen flange head screws and remove upper cover
from transaxle case.
22.Remove oil seal from upper cover and discard seal.
Figure 31
1. Flange head screw
2. Speed sensor
3. Flange head screw (4)
4. Upper cover
5. Oil seal
1
2
3
4
5
To Next Page
Loading...
