Toro Multi Pro 1750 - Page 255

Multi Pro 1750 Page 7 − 29 Drive Train
25.Disassemble reverse shaft assembly:
A. Use a bearing puller to remove bearing from re-
verse shaft.
B. Remove gear.
C. Use a bearing puller to remove bearing from re-
verse shaft.
1. Bearing
2. Gear
3. Bearing
4. Reverse shaft
Figure 36
1234
26.Disassemble countershaft assembly:
A. Use a bearing puller to remove bearing from
countershaft.
B. Remove collar and retaining ring.
C. Remove countershaft gear.
D. Remove retaining ring and collar from shaft.
E. Use a bearing puller to remove two (2) bearings
from shaft.
1. Bearing
2. Collar
3. Gear
4. Collar
5. Retaining ring
6. Retaining ring
7. Bearing (2)
8. Countershaft
Figure 37
8
7
5
6
4
3
2
1
27.Disassemble fork shaft assemblies:
A. Remove lock pin from 2nd−3rd fork shaft assem-
bly.
B. Note or mark mating shafts and forks for as-
sembly.
C. Remove shift fork from fork shaft.
D. Remove lock pin from 1st−R fork shaft assembly.
E. Remove shift fork from fork shaft.
1. Lock pin
2. Shift fork
3. Fork shaft
Figure 38
Drive Train