Multi Pro 1750Page 7 − 44Drive Train
19.Install reverse shaft into transaxle case. Rotate main
shaft and reverse shaft gears to mesh gears when in-
stalling.
1
2
1. Reverse shaft 2. Bearing (gear case)
Figure 79
20.Install center plate:
A. Insert dowel pins into transaxle case.
B. Apply silicone sealant onto mating surface of
center plate.
C. Position center plate to transaxle.
D. Install and tighten fifteen (15) flange head screws
to a torque from 18 to 22 ft−lb (25 to 29 N−m).
E. Apply multi−purpose grease onto lips of oil seal,
then insert oil seal flush with face of housing.
Figure 80
18 to 22 ft−lb
(25 to 29 N−m)
NOTE: The thickest shim of the shim set should be
positioned against the retaining ring.
21.Insert tabbed shim against the bearing. Insert shim
set against the tabbed shim. Use thickest shims in set
possible, that will permit installation of the retaining ring.
1
4
2
1. Seal cap
2. Shims
3. Shim
4. Snap ring
Figure 81
3
To Next Page
Loading...
