Toro Reelmaster 5010- H - Page 348

2.Unplugthe48Vdcbatterydisconnecttopreventunexpectedcuttingunitoperation.RefertoConnecting
andDisconnectingthe48VdcBatterySystem(page19).
3.LocateandremovefuseF2-3(35amp)fortesting.
4.Measuretheresistanceofthefuse.Thereadingshouldbe1ohmorless.
Pass
Thefusetestedgood.InstallfuseF2-3.GotoStep3.
Fail
Thefusefailedthetest.Replacethefuse.GotoReturningtheMachinetoService(page22)and
followthestepslisted.
Step3:Inspectthewiringforcuttingreelmotor3.
1.RefertoFigure152tolocatecuttingreelmotor3.
g032972
Figure152
1.Cuttingunit1,whichincludescuttingreelmotor14.Cuttingunit4,whichincludescuttingreelmotor4
2.Cuttingunit2,whichincludescuttingreelmotor25.Cuttingunit5,whichincludescuttingreelmotor5
3.Cuttingunit3,whichincludescuttingreelmotor3
2.Followthecuttingreelmotorcablefromcuttingreelmotor3totheconnectorplatemountedonthe
tractionunit.
Note:The2cuttingreelmotorcableconnectorsaresecuredwithclipstotheconnectorplate.The2
mainharnessconnectorsarenotsecuredtotheconnectorplate.
3.DisconnectmainharnessconnectorsP40andP41fromthecuttingreelmotorcableconnectorsmounted
onthetractionunit.
4.Inspectthe2cuttingreelmotorcableconnectorsandthe2mainharnessconnectorsforthefollowing:
•damage
•corrosion
•debris
•properalignmentandseatingofthepinsinsidetheconnectors
5.Inspectthe2cuttingreelmotorcableconnectorsforproperwirecolorperpin,asshowninthefollowing2
tables.
CuttingReelMotor,4-PinConnector
348