Toro Reelmaster 5010- H - Page 353

3.LocateandremovefuseF2-4(35amp)fortesting.
4.Measuretheresistanceofthefuse.Thereadingshouldbe1ohmorless.
Pass
Thefusetestedgood.InstallfuseF2-4.GotoStep3.
Fail
Thefusefailedthetest.Replacethefuse.GotoReturningtheMachinetoService(page22)and
followthestepslisted.
Step3:Inspectthewiringforcuttingreelmotor4.
1.RefertoFigure153tolocatecuttingreelmotor4.
g032972
Figure153
1.Cuttingunit1,whichincludescuttingreelmotor14.Cuttingunit4,whichincludescuttingreelmotor4
2.Cuttingunit2,whichincludescuttingreelmotor25.Cuttingunit5,whichincludescuttingreelmotor5
3.Cuttingunit3,whichincludescuttingreelmotor3
2.Followthecuttingreelmotorcablefromcuttingreelmotor4totheconnectorplatemountedonthe
tractionunit.
Note:The2cuttingreelmotorcableconnectorsaresecuredwithclipstotheconnectorplate.The2
mainharnessconnectorsarenotsecuredtotheconnectorplate.
3.DisconnectmainharnessconnectorsP48andP49fromthecuttingreelmotorcableconnectorsmounted
onthetractionunit.
4.Inspectthe2cuttingreelmotorcableconnectorsandthe2mainharnessconnectorsforthefollowing:
•damage
•corrosion
•debris
•properalignmentandseatingofthepinsinsidetheconnectors
5.Inspectthe2cuttingreelmotorcableconnectorsforproperwirecolorperpin,asshowninthefollowing2
tables.
CuttingReelMotor,4-PinConnector
353