Toro Reelmaster 5010- H - Page 400

Thefaultmovestothe
newposition.
Ifthefaultfollowsthecuttingreelmotortothenewcuttingunit,replacethe
cuttingreelmotor.GotoStep3.
Thefaultrepeatsatthe
originalposition.
Ifthefaultrepeatsatthecuttingunit4position,gotoStep4.
Thefaultstopped
repeating.
Ifthefaultnolongerrepeats,notethepositionchangeofthecuttingreelmotor
inthemaintenancerecordsforthemachine.Shouldthefaultrepeatinthe
future,troubleshootingmayberesumedwhereyouleftoff.GotoReturningthe
MachinetoService(page22)andfollowthestepslisted.
Step3:UseToroDIAGtoprogramthereplacementcuttingreelmotor.
1.Removetheaccesspanelfromtheoutercoverofthecontrolarm.
2.ConnectaPCwithToroDIAGsoftwaretothemachineviaaToroDIAGCable(PartNo.115-1944).Refer
toToroDIAG-QuickStart(page24).
3.UsetheToroDIAGsoftwaretoreprogramthemachineinaccordancewithToroDIAGUser’sGuide.The
replacementcuttingreelmotorisprogrammedduringthereprogrammingofthemachine.
4.DisconnecttheToroDIAGcablefromthemachine.
5.Installtheaccesspanelontotheoutercoverofthecontrolarm.
6.GotoReturningtheMachinetoService(page22)andfollowthestepslisted.
Step4:Inspectthewiringforcuttingreelmotor4.
1.GotoPreparingforTroubleshootingand/orT esting(page22)andfollowthestepslisted.
2.Unplugthe48Vdcbatterydisconnecttopreventunexpectedcuttingunitoperation.RefertoConnecting
andDisconnectingthe48VdcBatterySystem(page19).
3.DisconnectmainharnessconnectorsP48andP49fromthecuttingreelmotorcableconnectorsmounted
onthetractionunit.
4.Inspectthe2cuttingreelmotorcableconnectorsandthe2mainharnessconnectorsfordamage,
corrosion,debris,andproperalignmentofthepinsinsidetheconnectors.
Pass
Thewiringinspectionpassed.GotoStep5.
Fail
Oneormoreoftheinspectionchecksfailed.Repairorreplacethewornordamagedparts.Goto
ReturningtheMachinetoService(page22)andfollowthestepslisted.
Step5:Measure48VdcpowerinmainharnessconnectorsP48and
P49.
Note:ConnectordiagramsareavailableinStep6.
1.Verifythattheengineisshutoff.
2.DisconnectmainharnessconnectorsP48andP49fromthecuttingreelmotorcableconnectors.
3.RotatetheignitionkeytotheONposition.
4.Measurethevoltagebetweenpins1and2ofconnectorP49.Thereadingshouldbe48Vdc.
5.MeasurethevoltagebetweenP48pin1andP49pin2.Thereadingshouldbe48Vdc.
6.RotatetheignitionkeytotheOFFposition.
Pass
Thevoltagereadingsweregood.GotoReturningtheMachinetoService(page22)andfollow
thestepslisted.
Fail
Thevoltagereadingswerenotgood.GotoStep6.
400