Toro Reelmaster 5010- H - Page 47

Pass
Themachinestartedandthefaultdidnotrepeat.GotoReturningtheMachinetoService(page22)
andfollowthestepslisted.
Fail
Thefaultrepeated.GotoStep3.
Step3:TesttheignitionswitchusingtheInfoCenter.
PerformthefollowingstepstotesttheignitionswitchusingtheInfoCenter(Figure29):
1.TurntheignitionkeytotheONposition.
2.OntheInfoCenter,presstheleftbuttonasneededtodisplaytheMainMenu.
3.PressthecenterbuttonasneededtohighlighttheDiagnosticsitem.
4.PresstherightbuttontodisplaytheDiagnosticsmenu.
5.PressthecenterbuttonasneededtohighlighttheEngineStartitem.
6.PresstherightbuttononcetodisplaytheEngineStartmenu.
Note:TheInputsitemisselectedwhentheEngineStartmenuappears.
7.PresstherightbuttontodisplaytheInputsmenu.
Note:OntheInputsmenu,youshouldseetheKeyStartitemdisplayed.Becausetheignitionkeyisin
theONposition,theKeyStartitemstatusreadsOFF.
8.TurntheignitionswitchtotheST
ARTpositionandholdtheswitchintheSTARTpositionfor5seconds,
andthenreleasetheswitch.
Note:Iftheignitionswitchisworkingcorrectly,theKeyStartitemstatuschangesfromOFFtoONand
thenbacktoOFFwhenthekeyisreleased.
9.TurntheignitionswitchtotheOFFposition.
g020650
Figure29
1.Indicatorlight3.Middlebutton:pressittoscrolldownmenus.
2.Rightbutton:pressittoopenamenuwherearightarrow
indicatesadditionalcontent.
4.Leftbutton(MenuAccess/BackButton):pressittoaccessthe
InfoCentermenus.Youcanuseittobackoutofanymenu
youarecurrentlyusing.
Pass
TheignitionswitchpassedtheInfoCentertesting.GotoReturningtheMachinetoService(page22)
andfollowthestepslisted.
Fail
TheignitionswitchfailedtheInfoCentertesting.GotoStep4.
Step4:Testtheignitionswitchandcircuitwiringmanually.
1.Refertothe5010-HServiceManual,Chapter5,ComponentTestingsection,IgnitionSwitchfor
instructionsonhowtomanuallytesttheswitch.
47